I bought a NUC: GMKtec Nucbox G3
and a 2.5Gbps switch:keepLiNK 8 Port 2.5G Switch Unmanaged, Ethernet Switch with 8 x 2.5G Base-T Ports
But lshw reports it is connected at 1Gbps.It is NOT configured for autonegotiation, it is set to manual 2.5 Gbps/Full.
How do I get 2.5Gbps?
and a 2.5Gbps switch:keepLiNK 8 Port 2.5G Switch Unmanaged, Ethernet Switch with 8 x 2.5G Base-T Ports
But lshw reports it is connected at 1Gbps.
Code:
description: Ethernet interface product: Ethernet Controller I225-V vendor: Intel Corporation physical id: 0 bus info: pci@0000:03:00.0 logical name: enp3s0 version: 03 serial: e0:51:d8:11:83:c4 capacity: 1Gbit/s width: 32 bits clock: 33MHz capabilities: pm msi msix pciexpress bus_master cap_list ethernet physical tp 10bt 10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation configuration: autonegotiation=on broadcast=yes driver=igc driverversion=6.1.0-17-amd64 duplex=full firmware=1085:8770 ip=192.168.1.53 latency=0 link=yes multicast=yes port=twisted pair resources: irq:18 memory:80400000-804fffff memory:80500000-80503fffHow do I get 2.5Gbps?
Statistics: Posted by StevenFriedrich — 2024-01-11 04:08